Residential Electric Service Application Your browser does not have JavaScript capabilities enabled. This page (and other pages on this site) may not work as designed. It is highly recommended that you enable JavaScript and reload this page for optimum usability and experience. All required fields are marked with *This form could not be completed. Please review the highlighted messages below. This form is for New Residential Construction Meter Installation or Upgrade of Service. You can find the Non-Residential form here. Service Address*Address:*City:State:WI*ZIP Code:*Municipality:Select One...City of KaukaunaTown of BuchananTown of FreedomTown of HollandTown of KaukaunaTown of OneidaTown of VandenbroekVillage of Combined LocksVillage of Little ChuteVillage of WrightstownOther...MUNICIPAL PERMIT REQUIRED IN ALL CASES*Municipality Name:*Type of Dwelling:Select One...Apartment BuildingCondominium / TownhouseDuplexMobile HomeSingle FamilyOther...*Dwelling Type Name:*# of Units:Responsible Party for Monthly Utility Bills*Full Name:*Primary Phone #:Alternate Phone #:*Email Address:*Billing Address:*Billing City:*Billing State:*Billing ZIP Code:Electrician / Builder Information*Name:Full Name or Business Name*Phone #:Service InformationAll residential services are 120/240 volt single-phase.*Use of Service:Select all that apply. Temporary Service (minimum $175 charge) Electric Heat Central Air Conditioner Ground Source Heat Pump Electric Water Heater Electric Range Electric Dryer*Type of Service: New Overhead Service New Underground Service Service Upgrade*Old Service Size:*New Service Size: 100 Amp 200 Amp 320 Amp*Checklist:Each item must be completed Application card filled out by owner/electrician/builder Address posted Meter socket location approved by utility Meter socket & service equipment installed Service inspected-or-affidavit signed (per municipality) Submit completed application (see below) Overhead services are scheduled on Tuesdays or Fridays. Contact the utility at least 48 hours in advance. *Checklist:Each item must be completed Application card filled out by owner/electrician/builder Address posted Meter socket location approved by utility Meter socket & service equipment installed Service inspected-or-affidavit signed (per municipality) Backfilled and final grade established Cable route cleared of all obstructions Winter charge (November 15 - March 15) = $250 Submit completed application (see below) An underground service lateral may require a payment in advance if placed in an area served by existing overhead utility facilities. Underground services may take several weeks to energize once the above steps are done, dependent upon utility work load and weather. Utility is not responsible for damage to unmarked privately owned underground facilities. Acknowledgment & Signature*Applicant's Name:*Email Address:The signer's name above is required before signing.*Acceptance: I confirm the information above is accurate and checklist items are complete.Signature: Processing...
